palms macbook pro retina laptop skin – green one size at urban outfitters This is a topic that many people are looking for. caraimica.org is a channel providing useful information about learning, life, digital marketing and online courses …. it will help you have an overview and solid multi-faceted knowledge . Today, caraimica.org would like to introduce to you 13. Following along are instructions in the video below:
You for choosing co. Where for your macbook pro skin. The installation process is the the same for the 13 and 15 inch macbook pro laptops for this installation you need a microfiber cloth blow dryer or a heat gun lets get started if you ordered a full set there should be three sheets top keyboard and trackpad and the bottom you can also skip directly to any part of the installation start by cleaning the top lid with the microfiber cloth peel the skin off the backer.
Then reapply. It to the backer. With the top and left edge hanging over about a half an inch start by lining the top left corner.
Youll want to keep it back from the edge about a half the thickness of a credit card line up the top edge first then check the left side to make sure the alignment is straight.
If you have trouble with the alignment just slowly pull the skin off and start over if it looks good go ahead and press. It down along the top edge next lift up the skin and slide down the backing paper. Keep working the skin from the top down keep pulling the backing paper out a few inches.
At a time until you reach the bottom edge using a blow dryer heat. The corners and along the edges for a few seconds to soften up the material. Then press it down from the inside out if any air bubbles appear try to work them to the outside edge clean the keyboard and trackpad area with the microfiber cloth go ahead and peel the trackpad skin then apply it starting along the top or bottom edge once aligned go ahead and press.
It down firmly for the keyboard slowly.
Peel each edge of the keyboard skin before peeling the whole thing off the backer. Then reposition. It on the backer.
With the top edge hanging over about a half an inch. Now align. The two top inside corners shown here position it from the edge again about half the thickness of a credit card.
Once the lined go ahead and press down along the whole top edge now slowly peel up the skin and reposition.
The backer. So it will freely slide out start sliding the back route a few inches at a time. While you press down around the keys palm rest and speaker area again using the blow dryer warm up the edge around the keyboard now slowly press.
The skin down around the whole keyboard finish by pressing down around all the individual keys. Finish. The laptop by again cleaning the bottom with the microfiber cloth peel the skin off the backer and reposition.
It with the top edge hanging over again about a half inch align.
The two top inside corners position. It from the edge again above half the thickness of a credit card after aligning the top edge press. It down working from either side reposition.
The backer then continue to press it down as you slide. The backer out finish by heating the corners and edges and press from the inside out if the edges of your skin. Feel a little sharp.
You can use a credit card to smooth the edges down your laptop is now complete. If you have any additional questions. Please feel free to contact us at color or calm.
Thank you for watching all the articles on the topic 13. All shares of caraimica.org are very good. We hope you are satisfied with the article. For any questions, please leave a comment below. Hopefully you guys support our website even more.